Heatit Z-Dim is a Z-Wave rotary dimmer for many different types of light sources. The Heatit Z-Dim works on low loads without causing the lights to flicker. It dims LED-bulbs from 1-200VA , 230V halogenand incandescent bulbs, dimable LED-drivers and electronic transformers. The dimmer is not affected by startup inrush currents. L+N leads must be connected.
The dimmer is equipped with a multiway switching option. This allows you to light and dim a light source from one dimmer, and later turn it off with another one. Very practical for stairwells, long hallways etc.
The dimmer fits into standard Gira System 55 frame systems.
- Z-Wave rotary dimmer
- Scene Controller
- 230V halogen
- Incandescent lightbulbs
- Dimable LED-drivers
- Electronic transformers
- Starts at 1VA and dims up to 200VA LED
- Trailing edge
- Multiway switching option
- Electronic thermal cutoff with automatic reset
- Firmware updates (OTA)
- Power metering
- Supports encryption mode: S0, S2 Authenticated Class,
S2 Unauthenticated Class
This product is a security enabled Z-Wave Plus product with
encryption. The product must be used with a security enabled
Z-Wave Controller in order to fully utilize the product.
Protocol Z-Wave, 868,4MHz
Chip Z-Wave 500 chip
Rated voltage 230V AC 50Hz
Power 1 – 200VA
Input current 0,9A
Controls Push and rotary dimmer
Operating temperature -20°C – 40°C
Connection Max. 2,5mm²
Flush mounting depth 15mm
IP Code IP 20
Size (LxWxH) 84 x 84 x 43mm
Approvals Z-Wave Plus
EN 55015/A2: 2009, EN 61547:2009
EN 60669-2-1/A12:2010 EN 60669-1:A2:2008
EMC 2014/30/EU, RoHS 2011/65/EU
The device is maintenance-free.
|art. no.||Product||Z-Wave frequenCY|
|14 444 44||Heatit Z-Dim 200V – LED-dimmer||EU 868,4 MHz|
The product must be installed in accordance with current version of the installation guide and national building codes. See the installation guide for further information.