Heatit Z-Push Button series

Z-Wave Switch

Heatit Z-Push Button is a battery operated wall switch with either 2, 4 or 8 buttons. The switch enables you to control the Z-Wave-products in your smart home system. Managing your Z-Wave products becomes easy and practical. The switch can be set up to control scenarios or work in associations with other Z-Wave products.

Heatit Z-Push Button may not be used as a stand-alone unit; it must be included in a gateway to function.

The switch fits into System 55 frames.

The switch is easy to install, and may be fastened with screws or double-sided tape.


 

Features

  • Battery operated wall switch
  • Fits Gira System 55
  • LED-diode
  • Easy to install with screws or double-sided tape
  • Supports encryption modes S0, S2 Authenticated Class, S2 Unauthenticated Class

This product is a security enabled Z-Wave Plus product with
encryption. The product must be used with a security enabled Z-Wave Controller in order to fully utilize the product.

Technical data

Protocol Z-Wave, 868,4MHz
SDK 6.71.01
Chip Z-Wave 500 chip
Power 1 x CR2450 battery
Operating temperature 0 – 40°C
Relative humidity 8% – 80%
Range Up to 20 meters (depending on surroundings)
IP Code IP 20
Size (LxWxH) 71,2 x 71,2 x 13,6 mm

Explorer Frame Support Yes
Device Type Wall controller
Generic Device Class Switch Remote
Specific Device Class Switch Remote Multilevel
Routing No
Flirs No

Approvals CE
RoHS 2011/65/EU

Warranty

Dimensions

Heatit Z-Push Button 2 dimensional scheme.

Download documents

The product must be installed in accordance with current version of the installation guide and national building codes. See the installation guide for further information.

© 2019 Heatit Controls
post@heatit.com